Rage3D.com
Click for Page List Next Page
Print Article
Product : ATI Silencer 1,2 and 3
Company : Arctic Cooling
Author : Mark 'Ratchet' Thorne
Date : September 14th, 2004

Test Setup

To give a more accurate representation of the performance of these coolers I decided to setup a system a typical user would have. I used a standard steel 17-inch mid-tower case with an 80mm front intake fan and a silent 80mm rear exhaust fan. The power-supply was a 350w dual-fan Enermax and the CPU cooling fan was a stock AMD heatsink/fan unit which cooled an AMD Athlon XP 2500+ (1.8GHz Barton).

The rest of the components of the system were equally typical: a 7200RPM Seagate hard drive, 52x CD-Rom, 52x/32x/52x CD-RW, SoundBlaster soundcard, two 256MB DDR DIMMS, and an ATX nForce2 motherboard.

The videocards and coolers I used are listed in the table below:

Videocard Coolers Tested
ABIT Radeon 9800XT Stock
ATI Silencer 3
ATI Radeon 9800 Pro Stock
ATI Silencer 1
VGA Silencer rev2 (High)
VGA Silencer rev2 (Low)
Zalman ZM80C-HP Heatpipe
ATI Radeon 9600XT Stock
ATI Silencer 1
ATI Silencer 2
Vantec IceBerq4

I used the Arctic Cooling silicone thermal paste supplied with each of the ATI Silencer units when installing the coolers.


Testing Method
ATI's OverDrive panel was used to monitor the graphics core temperature for the videocards that supported that feature. For the 9800 Pro I attached a thermal probe to the underside of the cooler as close as possible to the core and monitored the temperature using a Cooler Master Aerogate II display unit.

I used Motherboard Monitor to monitor and log temperatures during each phase of testing. The system was allowed to idle on the Windows desktop for two hours after which time I recorded the idle temperatures. After that I began to test Load temperatures by running a loop of the four game tests in 3DMark03 for an hour.




All graphics and content on this page are ©2021 Rage3D.com
Reproduction in whole or in part is strictly prohibited.